Viewing 4 posts - 1 through 4 (of 4 total)
  • Kyle76
    Participant
    February 3, 2015 at 9:20 am
    Post count: 7
    #695 |

    I bought an iRig BlueBoard for controlling loops. I set one pedal to return to the previous mark. However, I have some loops that have smaller loops within them, and if I pass a mark for one of these loops, when I try to return to the beginning of the selected loop, it goes back to the last mark passed, not the beginning of the longer loop I am working on. What command do I need to return to the beginning of the selected loop, not the closest previous mark?

    tony_anytune
    Keymaster
    February 3, 2015 at 9:23 am
    Post count: 300
    #696 |

    You want the “Go to Loop A” command – that would take you to the beginning of the loop. The default MIDI controller for it is 15.

    Sean.

    Kyle76
    Participant
    February 3, 2015 at 10:09 am
    Post count: 7
    #697 |

    Thanks, Sean. I figured there was a specific command for it. Well done!

    tony_anytune
    Keymaster
    February 3, 2015 at 10:17 am
    Post count: 300
    #698 |

    No problem!

    Like the rest of Anytune, there are lots of options and it can be hard to find exactly what you’re looking for.

    BTW, I’m happy to hear that you managed to get the BlueBoard going since it is not very intuitive how the various pieces need to be setup to get them both communicating.

    Sean.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.